Hambrew Links

Close 136 kHz Projects

Close 492 kHz Projects

Close 500 kHz Projects

Close Multiband HF Projects

Close 160m Projects

Close 80m Projects

Close 60m Projects

Close 40m Projects

Close 30m Projects

Close 20m Projects

Close 17m Projects

Close 15m Projects

Close 12m Projects

Close 10m Projects

Close 6m Projects

Close 4m Projects

Close VHF Airband

Close 2m Projects

Close 70cm Projects

Close 23cm Projects

Close 13cm Projects

Close 9cm Projects

Close 3cm Projects

Close 1,25cm Projects

Close EHF Projects

Close Antenna Matches

Close Shack Accessories

Close Power Supplies

Close Test Equipment

Close µController Arduino

Junk Box Circuits

Close Tubes

Close Transistors BC-Serie

Close Transistors BD-Serie

Close Transistors BF-Serie

Close IC 74XX-Serie

Close IC 74LSXX-Serie

Close IC 74SXX-Serie

Close IC LM-Serie

Close IC TDA-Serie

HF Propagation
Visits

   visitors

   visitors online

Rate this Site

The DXZone.com

(with 10 = top)

Search




Transistors BC-Serie - BC548

Datasheet BC548 Philips
http://www.hebertech.com/view/1850-philips-bc548.pdf
 
 

Click to enlarge15V Dual Power Supply For Preamplifiers
This is 15v dual power supply for preamplifiers, which it can provide output +15V/-15V regulator using transistors and zener diode, so easy to find parts and build easily it.
https://www.eleccircuit.com/dual-dc-regulator-15v-using-c1061-and-a761/

Click to enlarge5 channel graphic equalizer by BC548 transistor
The equalizer circuit can adjust the frequency to 5 channel is 60 Hz, 100 Hz, 1 kHz, 3 kHz and 12 kHz.
If the system is used in stereo, then build up to another set.
http://www.eleccircuit.com/5-channel-graphic-equalizer-by-bc548-transistor/

Click to enlargeBinaural Receiver for 40 Meters by WB8ICN
Actually it started out wanting to play with a ceramic resonator oscillator and this receiver had one. So I built the oscillator first…it worked first time and I am quite happy with the results thus far.
https://wb8icn.wordpress.com/2014/05/05/binaural-receiver-for-40-meters/

Click to enlargeBinaural Receiver Update by WB8ICN
Swapped out the experimental variable cap I was using for tuning and installed a salvaged 27 to 267pf variable cap. Also made some voltage measurements for my data book.
https://wb8icn.wordpress.com/2014/05/07/binaural-receiver-update/

Click to enlargeElektrische kaars
Om een kaars te laten branden, hebben we een verhittingsbron nodig (het vuur van een lucifer) en om hem te doven hoef je hem slechts uit te blazen. De volgende schakeling gedraagt zich op overeenkomstige wijze.
http://www.circuitsonline.net/schakelingen/98/lichteffecten/elektrische-kaars.html

Click to enlargeLie detector circuit
This is a false capture circuit or Lie detector circuit. The basic principle of the resistance of human skin. While dry skin is a resistance of about 1 Mega ohm but if the skin moisture resistance is reduced. When the body are excited or scared or not sure the skin is moist than usual.
http://www.eleccircuit.com/lie-detector-circuit/

Click to enlargePre amplifier with transistors BC548
Pre amplifier circuit with transistors can be used to supply source from 6-12Volt the current minimum is 2-3 mA and can extend the signal strength from up to 2 Volt.
http://www.eleccircuit.com/simple-preamplifier-circuits-by-transistors/

Click to enlargeSignal Frequency Beat Frequency Oscillator by VK3YE
The days when you could listen to amateurs on a simple shortwave AM receiver are with us again, thanks to the development of this one-transistor, frequency-agile signal frequency beat frequency oscillator.
http://home.alphalink.com.au/~parkerp/projects/projbfo.htm

Click to enlargeSimple flashing light by transistor BC548
WIDTH="96" HEIGHT="72"This circuit basically the base of LED Flashing circuit, the character generally be have Transistor stay 2 work alternate be be like the automatic switch that alternate work.WIDTH="96" HEIGHT="72"
http://www.eleccircuit.com/dual-led-flasher-by-2n2907/

Small FM radio receiverSmall FM radio receiver
WIDTH="96" HEIGHT="72"This circuit is FM radio receiver that very small size and works well, although the sensitivity is poor. The principle of this circuit is to use the generator frequency circuit.WIDTH="96" HEIGHT="72"
http://www.eleccircuit.com/small-fm-radio-receiver/
 

Click to enlargeThe Op-amp IC tester circuit
This is an simple op-amp IC tester circuit that cheap and easy to build. for test many op-amp ICs fast check.
http://www.eleccircuit.com/the-op-amp-ic-tester-circuit/
 
 

//www.free-electronic-circuits.com/images/projects/155/simple_crystal_test_circuit.gif" TARGET="_blank">Click to enlargeTwo Simple Crystal Test Circuits
WIDTH="96" HEIGHT="72"Two simple test circuits to check operation of quartz crystals.
In the first circuit, above the BC548 is wired as a colpitts oscillator, the frequency tuned by insertion of a crystal.WIDTH="96" HEIGHT="72"
http://www.free-electronic-circuits.com/circuits/two-simple-crystal-test-circuits.html


Creation date : 02/12/2012 @ 13:51
Last update : 23/09/2018 @ 23:42
Category : Transistors BC-Serie
Page read 16642 times


Print the article Print the article

Google Ads


^ Top ^