Hambrew Links

Close 136 kHz Projects

Close 500 kHz Projects

Close Multiband HF Projects

Close 160m Projects

Close 80m Projects

Close 60m Projects

Close 40m Projects

Close 30m Projects

Close 20m Projects

Close 17m Projects

Close 15m Projects

Close 12m Projects

Close 10m Projects

Close 6m Projects

Close 4m Projects

Close VHF Airband

Close 2m Projects

Close 70cm Projects

Close 23cm Projects

Close 13cm Projects

Close SHF Projects

Close Antenna Matches

Close Shack Accessories

Close Power Supplies

Close Test Equipment

Close µController Arduino

Junk Box Circuits

Close Tubes

Close Transistors BC-Serie

Close Transistors BD-Serie

Close Transistors BF-Serie

Close IC 74XX-Serie

Close IC 74LSXX-Serie

Close IC 74SXX-Serie

Close IC LM-Serie

Close IC TDA-Serie

HF Propagation


   visitors online

Rate this Site

The DXZone.com

(with 10 = top)


500 kHz Projects - Amplifiers

Click to enlarge0,5 kilowatts 500kc (630m) MOSFET PA by DJŘABR
It is hard to radiate a sufficiant amount of power on the 630m band since the efficiency of usual antennas is very poor (< 1%). Therefore we need to generate a lot of power. This document describes an amplifier using four MOSFETs with an efficiency of > 90%.

Click to enlarge100W MF CW PA by GW3UEP

Click to enlarge25W 472 kHz CW PA by GW3UEP

Click to enlargeA 500 Watt Output 4-400A Linear Amplifier for 600 Meters by W5JGV
With 3200 Volts on the anode, the amplifier draws 268 MA key down, CW mode. Screen voltage is 600, and the anode idle current is 80 MA. Idle dissipation is 256 watts. DC Input power is 915 watts, and the RF output power to the dummy load is 540 watts, for a calculated efficiency of 59% with good linearity.

Creation date : 12/02/2010 @ 22:55
Last update : 11/05/2017 @ 12:35
Category : 500 kHz Projects
Page read 18019 times

Print the article Print the article

Google Ads

^ Top ^